.. meta:: :scope: evolabel .. _ts_media_management-index: ################ Media Management ################ ========================= Label Is Not Fed Straight ========================= Print roller issues Verify that the print roller is clean and not worn and needs to be replaced. Also verify that the print roller is not thinner at the center. This happens if narrow media is used. I.e. that the print roller is more worn at its center. ========================== Label Is Not Fully Fed Out ========================== Media Not Detected * Verify that the correct media sensor type is selected. * Check that the media sensor is not blocked by labels or dust. * Verify the inner stabilizing bar. Print Roller Issues * Check that the print roller is clean and not worn or damaged and needs to be replaced Settings * Extra feed setting |br| Check the setting for the Extra Feed. If it is set to maximum value -5 mm a standard shaped label will not be fed out all the way. |br| :menuselection:`Settings --> Printer --> Label Dispensing --> Extra Feed` =================== Incorrect Paper Out =================== * Verify that the labels are attached to the paper core and that the paper core does not slip on the label roller. * Verify the :ref:`paper out sensor ` ================================== Label Collides with Applicator Pad ================================== Incorrect Print Position for the applicator See section Troubleshooting in the manual for the :ref:`current applicator ` and the :ref:`Label Dispensing Troubleshooting ` in this manual. ===================================================== Label Does Not Dispense Properly from the Label Liner ===================================================== See the :ref:`Label Dispensing Troubleshooting ` in this manual. Label Adjustment Won’t Start ---------------------------- Self adjusting applicator (like the QuickTamp) needs to be adjusted before the media can be adjusted. If the printer won’t start the media adjustment, start by verifying there are no applicator related error messages. .. |br| raw:: html